• ROZELLE, NSW
  • Essential Tips on How to Prevent Emergency Plumbing Leaks

    Plumber rozelle

    You just came from a long vacation and surprised by the flooding water in the entire house. Of course, you would not want this to happen if you just have prepared preventative measures beforehand. What then are the things you have had done? Learn the lessons from the following tips to stop the leak in your pipeline and restore your home’s water pressure.

    Use of the Plumber’s Epoxy Putty

    Check your pipeline system and lookout for the leak then mark the spot using a permanent marker. The reference mark will serve as an indication that you can find the leak once you have shut off the water pressure. Turn the main water valve of your house off. The valve is often situated near the water meter.

    Clean the area surrounding the threaded area of the pipe end or the leaking union with a wire brush. Remove the residual particles then use a cloth and wipe out the area to dry.

    Cover the surrounding surface of the leak with sufficient amount of the plumber’s epoxy putty. Do this thrice to completely cover the area. Use your hand to knead the putty until it becomes pliable for the application. You will notice that the putty will have one colour when it is properly kneaded. Start on the opposite side of the pipe’s hole when applying the epoxy putty and wrap it over the hole. Make sure to overlap the epoxy putty at about an inch on each side of the leak. See to it that the putty is tight when you wrap without having to stretch it thinly.

    Let the pipe repaired to cure in a significant amount of time as highly advised by the manufacturer. Take into account that most of the epoxy putties must be formed and must be in place in few minutes. This suggests that you need to work as quickly and as deliberately as possible. Usually, the water can be restored in one hour.

    Use of Clamps

    You need to clean the area surrounding the hole having medium-grit sandpaper. Remove any burrs or rough edges using a flat file. Get a piece of cloth to wipe the surface dry. Centre the pipe clamp over the rupture by positioning one-half of it. Do the same thing with the other half of the clamp. Line up of both clamp halves’ screw holes and insert the clamp screws.

    The next move you should take is to tighten up the clamp screws clockwise with the appropriate head screwdriver. Do the tightening in cross-pattern alternately. You will notice that the inner walls of the clamp are lined with the sealing material. The cross-pattern makes certain that the cross-pattern is tight and even fit on your pipe.

    Once the task above is completed, it is expected that the water pressure will be restored. This will be followed by check or examination of the leak. You will then be at your best if you will consider the tips provided above.